locomotive 2

[[LT] Rita Jakstiene]

Hello Loco 2 team,

We'd like to start producing the housing for the locomotive 2, but we're not sure if the drawings are final and correct, as there are some hesitations concerning the position of the buffers. We've asked the Portuguese to confirm that and haven't received their answer yet. Could anybody confirm that the drawings are final and correct?

Rita [LT]

[[PT] Jorge Mauricio]

Hello Rita & Loco 2 Team,

Our students are working on it, they are doing the final checking!
We give an anwer by the end of the day.

Greeting,
Jorge

[[PT] João Martins]

Hello Loco 2 team,

The design of the locomotive is what we sent, and the position of the buffers Jörg Fritsch also already sent.
But here if you have not seen the files.

[[DE] Jörg Fritsch]

Hello Loco Team, hello Joao, hello Rita,
please pay attention to the radius at front and back. (circa R124 , not R97)
 I Have another Radius on our chassis drawing, because your Radius at your solid is not R97.
We have have change one Radius of the chassis from R97 to R124. I hope it could fit together, because we have already mill the outline of the chassis.
See the Drawing of the chassis. The housing has to be cut out in the area of the buffers and the coupling.
Jörg Fritsch

[[PT] João Martins]

Hello Loco Team

I made some changes to the drawings of the Locomotive, so that the diameters are coincident with the measurements of the chassis
 
Please verify